Suzuki Cultus Front Suspensions Changing chimta,shock absorber
Changing the front suspension components on a Suzuki Cultus (also known as Suzuki Celerio in some regions) involves replacing parts such as struts or shock absorbers, coil springs, control arms, and other related components. It's essential to have the right tools and follow proper safety precautions when performing such work. Here are the general steps to change the front suspensions on a Suzuki Cultus:
Tools and Equipment Needed:
- Floor jack and jack stands
- Lug wrench
- Socket and wrench set
- Torque wrench
- Ball joint separator
- Pry bar
- Spring compressor (if replacing coil springs)
- Replacement suspension parts (struts, springs, control arms, etc.)
- Wheel alignment equipment (for after the replacement)
Procedure:
1. Safety Precautions:
- Ensure the vehicle is parked on a level surface and the parking brake is engaged.
- Wear appropriate safety gear, including safety glasses and gloves.
- Always use jack stands to support the vehicle when working underneath it.
2. Remove the Wheel:
- Loosen the lug nuts on the front wheel but do not remove them.
- Use a floor jack to lift the front of the vehicle and place it securely on jack stands.
- Fully remove the lug nuts and take off the wheel.
3. Disconnect Suspension Components:
- Depending on which suspension components you are replacing, you may need to disconnect the following:
- Sway bar end links
- Brake caliper (hang it from a suspension component to avoid damaging the brake line)
- ABS sensor (if equipped)
- Tie rod ends
- Ball joint from the control arm
4. Remove Old Suspension Components:
- If you are replacing the entire strut assembly, remove the bolts securing the strut to the knuckle and the strut tower.
- If you are replacing only the coil spring or other components, follow the manufacturer's instructions for disassembly.
5. Install New Suspension Components:
- Install the new strut assembly or suspension components in the reverse order of removal.
- Torque all bolts to the manufacturer's specifications using a torque wrench.
- If you are replacing the coil springs, use a spring compressor to safely compress and install the new springs onto the strut.
6. Reconnect Suspension Components:
- Reconnect the sway bar end links, tie rod ends, ball joint, and any other components you disconnected.
7. Reassemble the Brake Caliper:
- Reattach the brake caliper and tighten the bolts to the recommended torque.
8. Wheel Installation:
- Place the wheel back onto the wheel hub and hand-tighten the lug nuts.
- Lower the vehicle back to the ground using the floor jack.
- Tighten the lug nuts in a star or crisscross pattern to ensure even tightening.
9. Wheel Alignment:
- After changing suspension components, it's essential to have the wheel alignment checked and adjusted by a professional alignment shop.
10. Test Drive:
- Take the vehicle for a test drive to ensure that the new suspension components perform correctly and that there are no unusual noises or handling issues.
Replacing front suspension components can be a complex and physically demanding task. If you're not experienced with such work, it's advisable to seek the assistance of a qualified mechanic or an automotive repair shop to ensure the job is done correctly and safely.
Change front shock absorber rod
Chimta set price 7000pkr almost
Front shock absorber price 10000pkr almost
First remove tires then remove hub to shock bolts then uper shock nut or remove the shock from car
Now remove chimta bolt & nut or remove chimta from car
Now re assemble shock absorber & fit the spring on it
Work almost complete
Now assemble the shock absorber or chimta set in to the car or check the wheel alignment
0 Comments